ASTM A/AM Direct No.: + Fax No.: + Email: [email protected] Board No.: + ASTM A Specification for fittings used in high pressure gas and oil transmission and distribution system. Manufacturer of Carbon steel WPHY 60 pipe fittings, Exporter of a comprehensive range of products like CS ASTM A elbow, Reducer, Effortless ordering and.
|Published (Last):||23 January 2011|
|PDF File Size:||18.15 Mb|
|ePub File Size:||6.41 Mb|
|Price:||Free* [*Free Regsitration Required]|
Butt-welding fittings differing from these. These fittings a806 for use in. The material for fittings shall be fully killed fine — grain material made by a. All butt — weld tees manufactured by cold —forming methods shall be liquid.
ASTM A WPHY GR 60 Pipe Fittings, Carbon steel WPHY 60 buttweld fittings Manufacturer, Exporter.
No cracks shall be permitted. After the removal of any cracksthe tees shall be re. NDE personal shall be.
All fittings shall be furnished in the heat-treated condition. Fittings shall subsequently be heat treat edby normalizingquenchingand. All values are Maximum unless A range is stated.
There sults shall conform to Table 1 for either.
A860 WPHY 60 PIPE FITTTINGS
The chemical composition thus determined. The product analysis shall be the basis ast rejection. A chemical analysis shall be performed on deposited weld metal for.
The nickel content of the deposited weld metal. Standard Specimen, Size Specimen.
Carbon steel WPHY 65 buttweld fittings, ASTM A WPHY GR 65 Pipe Fittings Manufacturer, Exporter.
And over, Sizes tested Section;min. Rectangular For Less than [7. A refers to the high yield strength of the fittings.
How can I help you? What can I do for you? By Sea or By Land Packing: In pallets, in plywood cases, in bulk.
These fittings are for use in high — pressure gas and oil transmission and distribution system. Internal and external surface shall be examined when size permits permits accessibility. After the removal of any cracksthe tees shall be re- examined by the removal of any Acceptable tees shall be marked with the symbol PT or MT adtm, as applicableto indicate compliance.
The astn composition thus determined shall conform to Table 1. A chemical analysis shall be performed on deposited weld metal for each heat of filler metal orfor submerged arc weldingeach heat of filler metal and batch of flux the weld metal shall be deposited in accordance with the ast weld procedure.
The nickel content of the deposited weld metal shall not exceed 1. And over, Sizes tested Section;min, specimen, thickness [7.